Terracotta humidifying stones for cigars and tobacco - CLAY

It is very simple. Submerge the stone in distilled water for a few minutes until small air bubbles stop rising: this means the pores are full. Take it out, then wipe its surface carefully with a clean cloth so that it is damp through to the core but not dripping. Place it back in your case, tobacco jar, or humidor. When the stone becomes light-colored and dry to the touch again, it has released its water: simply repeat the process. There is no limit to the number of recharges.

This is not recommended. Tap water contains limescale and minerals that deposit in the clay's pores every time it evaporates. Little by little, the stone will absorb less effectively and may even develop an odor. Chlorine can also alter the delicate aromas of a cigar. Therefore, use distilled water, which is easily found in supermarkets or pharmacies. For cigar use, do not use a propylene glycol solution with these stones: they are designed for pure water and simple release.

No, and it is important to be aware of this. A clay stone provides humidity but does not regulate it: it does not reabsorb excess moisture if the air becomes too humid and does not aim for a specific percentage. This is why we present it as a supplementary tool, ideal in a travel case, tobacco jar, or small humidor holding up to fifty cigars. In a large humidor, a dedicated humidifier or two-way humidity packs are better. In any case, a hygrometer remains essential to verify that you are between 65 and 72%.

There is no universal rule, as it all depends on the airtightness of the container, its volume, and the ambient air. We advise starting small: one stone in a travel case or tobacco jar, one or two in a small humidor. Measure the humidity after twenty-four hours, then adjust by adding or removing a stone. The 3-piece set allows you to rotate the stones (one in service, one recharging), the 5-piece set equips two containers, and the 10-piece set equips several cases or a fuller humidor.

It is best to avoid this, especially right after recharging. A stone that is still wet placed against a cigar can leave a water stain on the wrapper, cause it to swell locally, or even encourage mold to grow. Instead, place it in a corner of the container, on a small saucer, in a compartment designed for the humidifier, or separated from the cigars by a thin cedar divider. In a tobacco jar, tuck it under the lid or in a small breathable fabric bag. The humidity will diffuse into the air without touching the cigars.

All three designs share the same natural clay and function; only their shape differs. Sunflower and Foliage are round stones 38 mm in diameter and 7 mm thick, adorned with a radiating floral motif and a plant motif, respectively. The Leaf stone adopts a leaf silhouette approximately 58 × 34 mm, which is slightly longer and practical for sliding along a side wall. The choice is therefore primarily aesthetic, or practical depending on the shape of the compartment to be equipped.

Yes, this is actually one of their traditional uses. In a tobacco jar or a well-sealed pouch, a recharged clay stone helps pipe tobacco maintain its suppleness and prevents it from becoming brittle between smokes. The principle is the same as for cigars: recharge with distilled water, wipe, and place the stone away from the tobacco, for example under the lid. Simply monitor the state of the tobacco: if it becomes too moist or sticky, remove the stone for a few days.